Axel Joost Electronics box version G

Electronics box Version G Ver. 2 with handlebar adapter
This is our latest electronics box for mini pushbuttons. It controls the most important electrical functions on the motorcycle from a central location. The following functions are supported by the electronics box and can be e.g.T. at any time easily reprogrammed by the user:

Control of turn signals, horn, starter relay, stopy
Control of high and low beams
Warning flashing function
2 x warning flashing b. Ignition on or engine off
Adjustable reset function of the turn signals
Limit light function via the turn signals (as with the Ami's)
1 button for start / stop or 2 separate buttons for start / stop possible
Input alarm switch
Brake light / taillight - combination possible. Then the brake light lights up at 50% when the brakes are not applied.
Control of the box from the neutral and side stand switch possible.
8 Status LED's on the cable outputs for easy checking of conditions


The handlebar adapter clips onto all pushbutton switches and slides into the handlebar. There is then only a thin line from the adapter to the electronics box. The G-Box has 8 status LED's on the cable outputs for quick installation and monitoring. The housing is waterproof cast with epoxy resin....

The various functions of the electronic box version G can be changed at any time. Before turning on the power to the box, press and hold the horn button until the power is on. After releasing the horn button the box is in program mode. A single warning flash indicates the programming mode. By pressing the left or right flashing button you can select the corresponding function as shown in the table below. This will take you to the next program mode, which is then indicated by 2 warning flashes. The following options are available:

Number of flashes Mode Button Left Button Right Description
1 x Show flashing Off On 2 x flashing when switched on
2 x Comfort flashing Off On Comfort flashing switches itself off
3 x Limiting light Off On Turn signals glow with 20 %, when off
4 x Stop Brake Light Off On Stop light glows at 50 % when off
5 x Start Stop Button 1 Button 2 Button 1 or 2 Button for Start /Stop
6 x Stand / Idle. Off On Switches ignition and starter off, if necessary

The functions are switched off after the 6. Pressing the horn for the first time is permanently stored in the E-Eprom, but can be changed again at any time (Tüv and marker light...). Before changing the program, switch off the supply voltage for at least 10 seconds to discharge the capacitors in the box.

Dimensions: E-box 50 mm x 42 mm x 12 mm, handlebar adapter 35 mm x 15 mm
Current consumption: maximum 20mA at 12V, due to the built-in LEDs
Housing: polycarbonate, waterproofed with epoxy resin
Input voltage: 6 - 13.8V, briefly up to 20 volts
Connections: Control section 0.5mm², power section 1 mm², 20 cm each
Maximum ambient temperature: 120 degrees Celsius
Allowable current from 12V connection: 20 amps

Not sure if this is the right control box for you? Then follow the link:
https://www.youtube.com/watch?v=rivetDWvNRro